Tips For Using Cold-drawn Bearing Steel

Jan 16, 2025

‌Tips for using cold-drawn bearing steel mainly include the following points‌:

‌Choose a suitable cold-drawing process‌: The choice of cold-drawing process has an important influence on the performance of bearing steel. The traditional process includes hot-rolled bars, spheroidizing annealing, cold drawing, recrystallization annealing and other steps. The new process includes hot-rolled wire rod blank breaking, spheroidizing annealing, continuous drawing into bars, etc. Selecting a suitable process can better control the hardness and organizational structure of the material.

‌Control parameters during cold drawing‌: During the cold drawing process, parameters such as temperature, speed and deformation need to be strictly controlled. For example, the temperature and holding time of spheroidizing annealing need to be precisely controlled to ensure that the microstructure of the material reaches the optimal state‌. In addition, overload or overspeed operation should be avoided during cold drawing to prevent material breakage or other problems‌.

‌Pay attention to the quality and hardness of the material‌: The hardness of the bearing steel bar after cold drawing needs to be controlled by appropriate heat treatment. For example, using a strong convection hood furnace for spheroidizing annealing can better control the hardness and organizational structure of the material‌.

‌ Regularly check and maintain equipment‌: When using cold drawing equipment, it is necessary to regularly check the operating status of the equipment and the integrity of the accessories to ensure that the equipment is in good condition. If any problems are found in the equipment, it should be repaired or replaced in time‌.

‌ Comply with safety operating procedures‌: When performing cold drawing operations, safety operating procedures must be strictly followed to ensure the safety of operators and equipment. Operators should wear appropriate safety protection equipment, such as gloves, goggles, etc., and set up obvious safety warning signs in the operating area‌.

You Might Also Like